• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 63 subscribers
  • Views 616 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM3409 "PGATE" SPEC

T Kishi
Genius 4425 points
Other Parts Discussed in Thread: LM3409

Hi 

My customer has questions.Please Cooperate me.

1.For [Driver Output resistance], What is the prescribed value of the "max" is?

2.If customwe put the Diode to PGATA-GND, do you have a problem?

⇒There is a need to put in customer internal regulations.Is there a possibility that malfunction occurs?

Best Regard

T Kishi

LM3409.pdf

    

  • 0
    TI__Mastermind 25500 points
    We do not have a spec for max Rpgate as it was not characterized over temperature. The 2ohm spec just gives you a typical rise/fall time of the FET gate depending on its capacitance. The more important spec is ICClim as it tells you what FET you can drive at what switching frequency (ICC = Qg*Fsw). Do you mean a diode from ground to PGATE with the anode to ground? If so there should be no issue with that but I am not sure what purpose that is supposed to serve, it may just introduce ground noise which likely wouldn't be an issue with a good layout. I am not sure what you mean by "internal regulations" however, could you please clarify? Thanks.