[ LM3544 ] Unused Output Port

Kenichiro

[ LM3544 ] Unused Output Port

Hi,

Since VBUS of OUT1 will be supplied from other power path, I don't use OUT1 port as drawing below.
Can I leave this OUT1 port open without any component? or please let me know, if you have other recommendation?
Also, do you recommend to disable OUT1 power switch with EN1 pin?

Thank you for your support in advance.
Regards,
Ken

over 9 years ago

0 Eric Wright over 9 years ago

TI__Mastermind 42795 points

Hello, I am moving your post to another location.

0 Kenichiro over 9 years ago in reply to Eric Wright

Mastermind 9165 points

Hi Eric,

Thank you, I did open this in wrong post, it should be in USB forum...
Sorry for inconvenience.

Thanks,
Ken

0 Eric Wright over 9 years ago in reply to Kenichiro

TI__Mastermind 42795 points

Hi Ken,

No worries as there are several forums where this part seems to fit. I moved it to what I felt was appropriate based on the "Monitors, Protectors, ..." description for this forum.

Welcome to the Battery Management Forum. Before posting:

Check if the issue has been already discussed in existing posts
Refer also to the FaQ for the most asked questions:

- Chargers
- Gas Gauge
- Monitors, Protectors, Authentication and ID

0 Alex Triano over 9 years ago in reply to Eric Wright

TI__Genius 12621 points

Hi Ken,

Sorry for all the confusion. I contacted the team of engineers who support this device and they will look over and respond to your questions.

Thanks!

Alex

0 Michael_DeSando over 9 years ago

TI__Genius 12630 points

Ken,

The output pin can be left open if not being used. To disable the output, the EN1 pin should be grounded for the LM3544-H since this version is active high. I would recommend disabling the OUT1 pin by grounding EN1 if you do not need to use OUT1.

0 Kenichiro over 8 years ago in reply to Michael_DeSando

Mastermind 9165 points

Hi Eric, Alex, MIchael,

Thank you for following up and sorry that I did post into invalid forum...
I will consult with my customer!!

Regards,
Ken

0 Eric Wright over 8 years ago in reply to Kenichiro

TI__Mastermind 42795 points

Hi Ken,

Actually, you did post to the correct forum originally but our team was not familiar with this particular device and I thought it should be moved (my fault). Thanks to Michael for eventually answering your post.

Have a nice week.

0 Kenichiro over 8 years ago in reply to Eric Wright

Mastermind 9165 points

Thanks, Eric!!

Power management

Power management forum

[ LM3544 ] Unused Output Port

[ LM3544 ] Unused Output Port

Welcome to the Battery Management Forum. Before posting: