TPS80032 / Total leakage current when VSYS load is disconnected and no switching

S.Satoshi

Other Parts Discussed in Thread: TPS80032

Hi,

Please let me ask about total leakage current when VSYS is disconnected and no swithcing as I mark as red arrow. Which spec in electrical characteristic should be referred?

Best Regards,

Sonoki / Japan Disty

over 7 years ago

0 Richard Solarski over 7 years ago

TI__Genius 10885 points

Hi Sanoki-san,

Section 4.5.16 shows the overall system current depending on the mode and supply, otherwise you would have to add up all of the applicable ground currents that are still supplied.

Best Regards,
Rick S.

0 S.Satoshi over 7 years ago in reply to Richard Solarski

Guru 21675 points

Hi Rick,

Sorry for my delayed response.
Now I'm supporting TPS80032 and find large leakage issue from few samples on customer's board. I'd like to send you customer's schematic, so can you contact me directly? Please find my email address in profile.

Best Regards,
Sonoki

Power management

Power management forum

TPS80032 / Total leakage current when VSYS load is disconnected and no switching