• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 63 subscribers
  • Views 404 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS65235: Enable function with I2C signal and Hardware setting.

HsinHung Lee
Intellectual 300 points
Part Number: TPS65235

Hi 

May you help me to clarify the enable function which one should be primary?  send enable command or Hardware enable? 

Could I change the enable status by hardware setting if I send the enable command by I2C?

Stanley

  • 0
    TI__Genius 15135 points
    Hi, Stanley

    No, during At I2C application, the EN pin=Low cannot make the LNB output disabled.

    Suggest to read the chapter 7.3.10 Disable and Enable in page 12 of datsheet.
    There are 2 applicaitons:
    1) At non-I2C application.
    2) At I2C application.

    thanks.

    zhao