LM2735YSDEVAL: LM2735 LLP/SOT TEST CLC2735TL REV.E

user4878864

Part Number: LM2735YSDEVAL

Hello,

I want to learn about connection pins (J1, JR5, JR6, JR7) of LM2735 LLP/SOT TEST evaluation board. Because I could not find the datasheet of this board and the meaning of pins on it. I want to drive 2 inductive sensor via this converter, is it possible and how can I connect them together? You can see the picture of my board.

Thank you for your support.

over 8 years ago

0 Brani Dubocanin over 8 years ago

TI__Expert 4100 points

Hello,
Jumper connectors you mentioned above are for test/evaluation purpose.
J1--> allows you to connect some passive load between output and GND
JR5, JR6, JR7 --> are placeholders for load connection between Vout & GND

Best regards
Brani

0 user4878864 over 8 years ago in reply to Brani Dubocanin

Prodigy 30 points

Thank you very much for your help Brani.

Power management

Power management forum

LM2735YSDEVAL: LM2735 LLP/SOT TEST CLC2735TL REV.E