This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQ76PL536A: OTP EPROM Program problem.

Part Number: BQ76PL536A

Hello everyone:

I want to re-program OTP-EPROM, and when finish step "E_EN " , it's all fine. I can read my data from register correctly,BUT when I send 0x27 to SHDW_CTRL, I can't read data correctly from register.

P.S.

1.I only program FUNCTION_CONFIG, for measure VBAT pin and change conversion time.

2.I've tried reset(power off and power on again) without write 0x27 to SHDW_CTRL, and read register "FUNCTION_CONFIG @0x40", I lost my data....I got 0x00..(If I didn't reset, I read data correctly)

Does anyone know  why I can't read correctly after write 0x27 to SHDW_CTRL??

Tnanks