BQ34Z100-G1: sequence for data flash access

arun

Part Number: BQ34Z100-G1
Other Parts Discussed in Thread: BQSTUDIO

Dear sir,

I want the I2C sequence for configure data flash register.for example i want to change number of series cell. For that send the sequence,like 0xaa,0x00 like that.

over 8 years ago

0 Onyx Ahiakwo over 8 years ago

TI__Guru* 76230 points

Most folks are out for the July 4th Holidays. We should get back to you after the break.

0 Onyx Ahiakwo over 8 years ago in reply to Onyx Ahiakwo

TI__Guru* 76230 points

Hi Arun,
That is not the recommended way to configure the gauge. You should use bqstudio to set the data flash parameters as per your application needs and then extract an srec after learning has been completed.

Also, for additional info communicating with the gauge, refer to these two documents below:
www.ti.com/.../slua790
www.ti.com/.../slua801

thanks
Onyx

Power management

Power management forum

BQ34Z100-G1: sequence for data flash access