GPCCHEM: Gauging Parameter Calculator error report

Caleb Buck

Prodigy 85 points

Part Number: GPCCHEM
Other Parts Discussed in Thread: GPCCEDV

I am getting the following results from submitting my zip data for the GPCCHEM tool

There was a problem with the content of the zip file.

Invalid Zip File Member - roomtemp_rel_dis_rel.csv
Required file 'hightemp_highrate.csv' is missing from the input zip file.
Required file 'roomtemp_lowrate.csv' is missing from the input zip file.
Required file 'lowtemp_highrate.csv' is missing from the input zip file.
Required file 'lowtemp_lowrate.csv' is missing from the input zip file.
Required file 'hightemp_lowrate.csv' is missing from the input zip file.
Required file 'roomtemp_highrate.csv' is missing from the input zip file

It looks to me like it is looking for some files that are not outlined in the following guide:

www.ti.com/.../slva725.pdf

over 7 years ago

0 Onyx Ahiakwo over 7 years ago

TI__Guru* 76230 points

it seems you must have either submitted your files to the wrong link i.e gpccedv or you must have set your processing type inn the config.txt file to 1 instead of 2.

check those two things and if you are still failing, attach the files you are submitting on here.
thanks
Onyx

0 Caleb Buck over 7 years ago in reply to Onyx Ahiakwo

Prodigy 85 points

I verified that processing type was set to 2 and that the correct link was used and it still resulted in the same automated response pasted above.

That being said, I was able to perform the selection manually using Mathcad.

Do you have an email address I can send the data to? I would like to figure out how to get the automated tool to work correctly.

Thanks,
Caleb

0 Onyx Ahiakwo over 7 years ago in reply to Caleb Buck

TI__Guru* 76230 points

Hi Caleb,

You can zip the files and upload it on here and we will try to figure out what is wrong.

thanks

Onyx

0 Caleb Buck over 7 years ago in reply to Onyx Ahiakwo

Prodigy 85 points

Voltage, Current and Temperature data has been removed to protect IP.SLC-201a (2).zip

0 Onyx Ahiakwo over 7 years ago in reply to Caleb Buck

TI__Guru* 76230 points

Your logged interval is 30s? That already in itself is a red flag as the max that is recommended for logging in other to use the tool is 10s.
Secondly, without the IVT, there is nothing that can be done with your files.
thanks
Onyx

0 Caleb Buck over 7 years ago in reply to Onyx Ahiakwo

Prodigy 85 points

The SLVA725 document states
"
The sampling interval can be from 5 to 100 s.
"
I cannot share IP here. Please provide an email address so that i can provide you the data.

Power management

Power management forum

GPCCHEM: Gauging Parameter Calculator error report