Other Parts Discussed in Thread: TPS65261
Tool/software: WEBENCH® Design Tools
Hi, I recently tried some setups for the TPS65261-1 without any problems
The part is not listed any more. Is support of this part discontoniued?
Than you, Alfred
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software: WEBENCH® Design Tools
Hi, I recently tried some setups for the TPS65261-1 without any problems
The part is not listed any more. Is support of this part discontoniued?
Than you, Alfred
Sorry for my misleading question stating "not listed". I give you some more details.
I tried following parameters for a design:
Vin 1-3 = 4.5 - 15V
Vout1 3.3V 2.00A
Vout2 2.5V 1.50A
Vout3 5.0V 1.00A
Ambient = 85
Open Design opens the Webbench Designer an I see "Initializing" and "loading" and then "Design Cannot Be Created"
I f I use "Show Why Parts Were Not Found" a Window opens where I see Vin 14 to 22 which is not what I wanted to simulate.
Only the default settings on the websites create a valid design. Changing some
If I try to create a new design inside the Webbench Tool using "See all Devices" the TPS65261 is not listed.
Thank you for your support, Alfred
Hi, Alfred
I have checked, the TPS65261-1 can meet your application.
I also try the Webbench designer, i get the same results: Show Why Parts Were Not Found, Vin 14 to 22V.
i think there must an error about Vin range in Webbench designer, i will feedback it to the TI model team to correct it.
Hi, Alfred
I haven't got feedback from model team, i will push them, sorry for late.
Before getting feedback, I recommend to start your design on the base of TI reference design, which is validated by many tests.
Below is TPS65261-1 EVM reference design.
http://www.ti.com/tool/TPS65261-1EVM?keyMatch=tps65261-1&tisearch=Search-EN-Everything
Hello Alfred,
The problem is with the VinMin=4.5V for the 3rd. channel Vout3 = 5V
I tried VinMin=7V and the design can be created. It is assumed that the same VinMin and VinMax values are applied to the three channels.
Best Regards,
Flora