UCD90320: PMBus Log Data

Harish kumar

Intellectual 435 points

Part Number: UCD90320

Could we see the monitor log data on PMBus same as we do in Fusion Digital Power Designer PMBus Logging?

We're driving PMBus through a Host Interface.

Thanks,

Harish Kumar

over 7 years ago

0 yihe over 7 years ago

TI__Guru 66240 points

Hi Harish

TI Fusion GUI has the pmbus logging function which stores all commands sent to the device. Is this what you are looking for?

This can be enable from Tools->PMbus logging.

You can also refer http://www.ti.com/lit/pdf/slvuaw9 for the details of the each command.

Regards

Yihe

0 Harish kumar over 7 years ago in reply to yihe

Intellectual 435 points

Hi Yihe,

My question is how to see the monitor log when the sequencer PMBus interface is connected to on-board Host Processor instead of Fusion GUI.

Thanks,
Harish Kumar

0 yihe over 7 years ago in reply to Harish kumar

TI__Guru 66240 points

you have to implemen the polling SW in your host to read the data from UCD device.
please refer the link i posted in the previous post.
Regards

Yihe

0 Harish kumar over 7 years ago in reply to yihe

Intellectual 435 points

Thanks Yihe.

Is "(EAh) LOGGED_FAULTS (MFR_SPECIFIC_26)" the right command for fault history?

-Harish Kumar

0 yihe over 7 years ago in reply to Harish kumar

TI__Guru 66240 points

yes command 0xEA provides a history of all faults.
command 0xEB and 0xEC coupled together provides a details of each faults.
Regards
Yihe

Power management

Power management forum

UCD90320: PMBus Log Data