BQ24650: BQ24650

Greetings of the Day
Thanks for your quick reply.
This is regarding PCB layout for input capacitor (BQ24650).
Is it a suitable layout for BQ24650, placing CBYPASS capacitor close as to the drain of the high-side MOSFET terminal and source of the low-side MOSFET terminal on the top layer & large capacitance capacitor is separated about 1.8cm
from CBYPASS on same side(Top Layer)?

For PCB layout, we recommend to place all the power components on the same side of the board and use ground layer as shielding. 

It is important to place the bypass capacitor close to the drain of the highside MOSFET and the source of the lowside mosefet to minimize the high frequency switching loop.

Greetings of the Day
Sorry to disturb you again.
I will be doing the same as you described, but my actual question was," Is there any need to separate the large capacitance capacitors (10uF x 3) from bypass capacitor (1uF )?

Thank You Sir..