BQ28Z610: bq28z610 golden file procedure question

LILITH

Intellectual 370 points

Part Number: BQ28Z610
Other Parts Discussed in Thread: BQSTUDIO, , BQ34Z100

Hello,

I have successfully completed the learning cycle but I do not find in bqstudio how to create the famous golden file.

Does this circuit use another mode to generate the production file?

Is there a specific document for this component?

Thank you in advance.

over 7 years ago

0 LILITH over 7 years ago

Intellectual 370 points

Nobody uses this circuit? Is there someone from TI?
Regards

0 Jagannath Sahoo Sahoo over 7 years ago in reply to LILITH

Prodigy 130 points

You can directly read the Srec file from the old one and then put it into the new hardware. It will work....
Can you help in Learning cycle of bq28z610?

0 LILITH over 7 years ago in reply to Jagannath Sahoo Sahoo

Intellectual 370 points

Hello,

thanks for you reply.

Yes of course I can read the old srec but normally the goal is to generate the new srec after successful learning cycle.

With other bq like bq34z100, for example, bqstudio has an icon that generates golden file and all files for mass production.

For bq28z610 ther is none at all curiously.

If you want some advices for the learning cycle I can help you.

Regards.

0 LILITH over 7 years ago in reply to Jagannath Sahoo Sahoo

Intellectual 370 points

If someone has already use bq28z610 thanks for advices for generate production file.
I don't understand why Texas don't reply and don't write a procedure for this news gauge...
Regards

0 Jagannath Sahoo Sahoo over 7 years ago in reply to LILITH

Prodigy 130 points

In 2nd stage i.e Relax for 5 Hours: [VOK] bit is cleared but [RDIS] is set and again [REST] bit is set.... Its confusing what exactly written on the document.... It's mention that "• The [VOK] and [RDIS] bits in the IT status() register clear once the gauge has taken an OCV reading
and qualified it for a Qmax update." and "The GaugingStatus[REST] flag is set when a valid OCV reading occurs" So please help me.... can i have your email id so we can discuss on it?

0 Jagannath Sahoo Sahoo over 7 years ago in reply to LILITH

Prodigy 130 points

In my case i Battery percentage is always showing 100%. Can you please tell me why this is happening?

0 LILITH over 7 years ago in reply to Jagannath Sahoo Sahoo

Intellectual 370 points

Hello Jagannath,

you can send me an email at this address: lilith_mail@laposte.net

Make an export of your parameters (*.gg.csv) and indicate me the reference of your cell, as well as the ID which you selected.

Regards.

0 LILITH over 7 years ago in reply to LILITH

Intellectual 370 points

Ok, it's fine now, I have finally found.

0 Jagannath Sahoo Sahoo over 7 years ago in reply to LILITH

Prodigy 130 points

How?

0 Bryan Kahler over 7 years ago in reply to Jagannath Sahoo Sahoo

TI__Mastermind 25955 points

Hi Lilith,

I am glad to hear the issue is resolved. If you need any more assistance with this part, please open a new thread and it will be responded to.

Thanks!

Sincerely,
Bryan Kahler

Power management

Power management forum

BQ28Z610: bq28z610 golden file procedure question