UCC256301: Question about UCC256301 SIMPLIS Model.

Bob Lee62837

Mastermind 7230 points

Part Number: UCC256301

Dear support member,

I have a question about UCC256301 SIMPLIS Model.

I opened UCC256301 SIMPLIS Model using SIMPLIS.

But SIMPLIS showed error mesage at Command window.

error mesage
"Decryption failed: Unable to decrypt the data" showed.

Is there anything solution?

SIMPLIS ver is 8.1.

Best regard.
Bob Lee.

over 7 years ago

0 Benjamin Lough over 7 years ago

TI__Mastermind 27085 points

Hi Bob,

Thanks for your interest in UCC256301. I will look into the simplis error message you are seeing. In the meantime, you could take a look at the webench model for UCC256301.

Best Regards,
Ben Lough

0 Benjamin Lough over 7 years ago in reply to Benjamin Lough

TI__Mastermind 27085 points

Hi Bob,

Just to clarilfy, is the version you are using the Simplis/Simetrix Elements free demo version?

Best Regards,
Ben Lough

0 Bob Lee62837 over 7 years ago in reply to Benjamin Lough

Mastermind 7230 points

Dear Benjamin Lough,

Thank you very much for reply.
I used SIMPLIS/Simetrix free demo version.

Can I use it for free demo version as well?

To operate free demo version,Is there anyghing solution?

Best regard.
Bob Lee.

0 Benjamin Lough over 7 years ago in reply to Bob Lee62837

TI__Mastermind 27085 points

Hi Bob,

It appears to be a problem with the free demo version. I am able to recreate the error message on the demo version of Simplis and can run the simulation without error in the full version.

Simplis is aware of this issue already but I'm not able to provide any sort of timetable for if/when this functionality will become available in the free version.

You can use Webench to create a model circuit based on your design requirements. The datasheet itself also contains steps for designing with UCC256301. These are the only options I can offer you at this time.

Best Regards,
Ben Lough

Power management

Power management forum

UCC256301: Question about UCC256301 SIMPLIS Model.