• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 372 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCC29002: SHUT, ADJ PIN LAYOUT

KIM Andy
Expert 2530 points
Part Number: UCC29002

HI 

What happens when you accidentally connect a KELVIN to sensing for voltage differences in the same line

I came to know.

Should SHUNT and ADJ of UCC29002 sense the voltage difference of the same line and apply Kelvin sensing in connection with LAYOUT connection?

  • 0
    TI__Mastermind 34465 points
    Hello Andy,
    The ADJ input is always taken from the positive side of the load.
    The shunt resistor can be on the positive side (for high line sensing) or the negative side (for low line sensing) of the load.
    The data sheet has many examples of this.
    Also there is a layout guidelines section that shows how to wire it up correctly.
    Regards
    John