TPS65910: About power-off at EEPROM mode

Tao_2199

Genius 5840 points

Part Number: TPS65910

Hello,

Regarding to power-off at EEPROM mode on TPS65910AA1, my customer is asking a question.

(Question)

･In this mode, does it need DEV_OFF or DEV_OFF_RST control bit for power-off?

According to datasheet page 47, these control bit are set to 1 for power-on disable.

But it seems that power-off sequence is started by falling edge of PWRHOLD on figure 5-2 (D/S page 39)

and figure 3 (User's Guide page6).

Is only PWRHOLD control needed for power-off at EEPROM mode?

Regards,

Tao2199

0 Brian Berner over 8 years ago

Power-on disable conditions only prevent the device from meeting the "power-on enable" requirements.

In other words, if the device is in the OFF state, the PMIC will not be allowed to go to the ACTIVE state if:

But when the device is in the ACTIVE state, the only requirement to sequence-down and go to OFF/SLEEP states is to pull PWRHOLD pin low.

0 Tao_2199 over 8 years ago in reply to Brian Berner

Genius 5840 points

Hello Brian,

I got it and informed to my customer.
Many thanks!

Regards,
Tao2199

Power management forum