BQ27411EVM-G1A: The RDL Tempco can not be set to 0,but the datasheet says it should be set to zero.

Lu Feiyue

Intellectual 660 points

Part Number: BQ27411EVM-G1A
Other Parts Discussed in Thread: BQSTUDIO

I can not set the parameter : RDL Tempco to 0 using bqStudio, because it alarms zero is beyond the minimum value.

But the datasheet says it should be set to zero.

Does it affect the operation of bq27411 if RDL Tempc is set to other values?

over 7 years ago

0 Kang Kang over 7 years ago

TI__Mastermind 24870 points

Hello Feiyue,

You do not have to change RDL Tempco for the bq27411. That is not a parameter which is used for the bq27411. Leaving it default is not an issue.

Thanks!

Power management

Power management forum

BQ27411EVM-G1A: The RDL Tempco can not be set to 0,but the datasheet says it should be set to zero.