WEBENCH® Tools/TPS54140A: Simulation Export to TINA

Simon Jagla

Expert 8405 points

Part Number: TPS54140A

Tool/software: WEBENCH® Design Tools

Hi Champs,

when exporting in Webench the simulation of a design to TINA it does only export the startup simulation.

Is it also possible to export the steady state, load transient....simulations directly to TINA?

Thanks a lot!

over 7 years ago

0 David Baba over 7 years ago

TI__Mastermind 40040 points

Hello Simon,

I have notified a person in a group that would be able to assist with your question.

Thanks.

David

0 Simon Jagla over 7 years ago in reply to David Baba

TI__Expert 8405 points

Are there any plans to add those features?

0 Atul_Kulkarni over 7 years ago in reply to Simon Jagla

Genius 4910 points

Hi Simon,

Simulation Export to TINA can be done directly only to startup test benches.
However you can manually change the parameters(initial conditions) in TINA by keeping simulation integration testbenches as reference and perform simulations for steady, line and load transients.

Thanks and Regards,
Atul

0 Friedl over 7 years ago in reply to Atul_Kulkarni

Prodigy 180 points

Hi Atul!

May I add the export of the steady state, load transient....simulations as a feature request?

But if I use Webench I'd really need to export those directly to be able to save them for documentation.

Time is rather limited you know ;-)

Power management

Power management forum

WEBENCH® Tools/TPS54140A: Simulation Export to TINA