BQ35100: Panasonic CR2450 Li/MnO2 Coin Cell

Glenn Pederson

Part Number: BQ35100
Other Parts Discussed in Thread: BQSTUDIO

In the Texas Instruments document SLUA904 it states, "If you cannot find your specific model contact Texas Instruments on model generation." I plan to use the bq35100 in SOH mode using a Panasonic CR2450 Li/MnO2 Coin Cell. What Chem ID should be used for this application? Thanks!

over 7 years ago

0 Kang Kang over 7 years ago

TI__Mastermind 24870 points

Hello Glenn,

We actually have a tech note that describes this on the bq35100 product page.

www.ti.com/.../getliterature.tsp

0 Glenn Pederson over 7 years ago in reply to Kang Kang

Prodigy 45 points

This tech note is the same document that I referenced in my original post. I do not see anywhere in this document where it specifies what Chem ID to use for the Panasonic CR2450 Li/MnO2 coin cell. This model battery is not listed in the bqStudio Software Chemistry Tab. Please advise. Thank you!

0 Kang Kang over 7 years ago in reply to Glenn Pederson

TI__Mastermind 24870 points

Hello Glenn,

Do you have a local TI FAE for support?

In this case, we will need to arrange the cells to ship to Dallas for characterization. If you don't have a local team, let me know. I will loop you into the right folks.

0 Glenn Pederson over 7 years ago in reply to Kang Kang

Prodigy 45 points

Please put me in touch with a local FAE. Thanks!

0 Glenn Pederson over 7 years ago in reply to Kang Kang

Prodigy 45 points

It would be helpful to talk with a TI FAE. Please forward contact information. Thanks!

0 Onyx Ahiakwo over 7 years ago in reply to Glenn Pederson

TI__Guru* 76230 points

Hi Glenn,
Given it means you do not have a local FAE contact, i will contact you offline and provide you the shipping details.

thanks
Onyx

Power management

Power management forum

BQ35100: Panasonic CR2450 Li/MnO2 Coin Cell