BQ24650: BQ24650 charge termination function

Hello Haut,
Yes, the correct procedure is to pull TERM_EN low to disable termination. You can connect the jumper on JP3 in the 1-2 position to do so. What do you mean by charging current is not normal? What is the voltage on the TERM_EN pin?

Hello Haut,
TERM_EN shouldn't affect your charge current. Are you talking about your charging current above? Can you tell me the voltage on the VFB pin when you connect TERM_EN in the 2 settings? What resistors are you using to configure your charge voltage, and for your sense resistor between SRP and SRN?

Hi TI ,

           1> TERM_EN conneect to GND,and it's voltage is 0V ;

            2> The resistors of the configuration charge voltage are 300K and 121K.

            3> Sense resistors are two 15 mohm in parallel.

           All the best,

Hello Haut,
From the previous question, at what VFB voltage are you seeing 0.6A. Is this a custom schematic or EVM board?