UCD9090A: Fusion Digital Power Designer switch project from offline to online mode

Chip Weller

Part Number: UCD9090A

Before I had hardware I created a UCD9090A power supply sequencer configuration for my project in offline mode.

I now have a EVM which I am setting up to test the configuration. However, I cannot see how I switch from the offline mode to the online mode?

Thanks, Chip Weller

over 6 years ago

0 yihe over 6 years ago

TI__Guru 65860 points

if the EVM is connected to the PC, after launched the fusion GUI, it automatically detects the live device and jumps into online mode. Then you can import the offline project file. Please watch the training video at training.ti.com/fusion-power-designer-import-and-export-project-files to see how to export and import project file.
please follow these and let's know which steps block you.
Regards
Yihe

0 Chip Weller over 6 years ago in reply to yihe

Prodigy 150 points

Thanks. I had expected that the import would be in the top level [System View] window using the File->Import System File. I could open the system file, but then it would not import. It did not occur to me to open the configuration window and try it from there.

Power management

Power management forum

UCD9090A: Fusion Digital Power Designer switch project from offline to online mode