• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 2 answers
  • Subscribers 64 subscribers
  • Views 363 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TLV62085: Switching freq & Iout

Shunsuke Nagata
Genius 12650 points
Part Number: TLV62085

Hi,

Could you please give me advice for below questions?

1.　Switching Freq is decreasing from 300mA load in Vin = 2.5V as below information. Is there idea why switching freq is decreasing in only Vin = 2.5V?

2.  The calculation for fPFM uses Iout. I guess VOS read Iout. If my understanding is correct, could you please let me know how to get Iout with VOS? (Is there internal current sense?)

Regards,
Nagata.

  • 0
    TI__Expert 8420 points
    Hi Nagata,

    I will check on the switching frequency and get back to you.
    I guess you are talking about equation 1 but I am not sure I understood your question properly. Iout is the load you apply on output of the device it is the operating condition you choose to operate the device for. If the DCDC converter is connected to another system you could measure the Iout with a current probe and use the value for your calculation.

    What is the end application ? what are your operating conditions?

    Thanks,
    Sabrina
  • 0 in reply to Sabrina
    TI__Genius 12650 points

    Hi, Sabrina,

    Thank you for your supports. I just want to know the mechanisum how to read the output current. Does the silicon get the output current? If yes, could you please let me know the mechanisum?

    And I don't want to share detail infomation for end application. Can you discuss it directly? Below is my e-mail address

    s-nagata@ti.com

    Regards,
    Nagata. 

  • 0 in reply to Shunsuke Nagata
    TI__Expert 8420 points

    Hi Nagata,

    I contacted you through mail.
    Regarding your first question, a 1uH inductor is used for the measurement on Fig 1.

    For Vin=2.5V, I expect to see less variation (similar to Vin=3.6V and Vin=6V) with a 0.47uH inductor.


    Regards,
    Sabrina