Other Parts Discussed in Thread: USB2ANY
Hi
I just bought LP5024EVM engeering development kit. I installed LP50 soft from TI.com on my TOSHIBA Rap top computer with Window 10 HOME. i connected USB2ANY and LP5024EVM by 10pin ribbon cable with +5V power supply. But display show no connected. I Installed USB2ANY explore soft and tested USB2ANY. this box did responded. i updated firmware. 2.8.2.0 I switched LP50 soft, but no connected on right corner of LP50 soft.
also I checked SDA and SCL signal for I2C signal by oscilloscope. but no signal on anytime on both lines. is this USB box broken ? or
Do you know how to test. USB2ANY and LP5024EVM board.
Thank you.
Takeshi