TINA/Spice/LM5035: What software can run the simulation model of LM5035

zoujiangyilang

Part Number: LM5035
Other Parts Discussed in Thread: TINA-TI,

Tool/software: TINA-TI or Spice Models

Hello
I am on your official website www.ti.com.cn/.../toolssoftware
Can be downloaded to the simulation model of the LM5035
This simulation model can be opened in OrCAD Capture CIS software.
However, my OrCAD Capture CIS software is a trial version with a limited number of components and cannot run simulations.
Can the simulation model of the LM5035 be run in TINA-TI or other simulation software?

over 6 years ago

0 Peter Meaney over 6 years ago

TI__Mastermind 31580 points

Hi

This applications note, www.ti.com/.../slva527.pdf, shows how to import the PSPICE in TINA.

Regards

Peter

0 zoujiangyilang over 6 years ago in reply to Peter Meaney

Genius 4560 points

Thank you, the documentation you provided can only import the model of the LM5035 device into TINA.
Can you import the entire LM5035-based half-bridge circuit model provided on your official website into TINA and perform circuit simulation?

0 Peter Meaney over 6 years ago in reply to zoujiangyilang

TI__Mastermind 31580 points

Hi

I think that you will need to redraw the circuit in TINA and then perform the circuit simulation.

Regards

Peter

0 zoujiangyilang over 6 years ago in reply to Peter Meaney

Genius 4560 points

ok，Thank you.

Power management

Power management forum

TINA/Spice/LM5035: What software can run the simulation model of LM5035