BQ40Z50-R1: BQ40Z50-r1

Naveesh Boppana

Part Number: BQ40Z50-R1

Hi ,

I was trying to check the functionality of OCC2 on fuel gauge and I set the OCC2 bit high is there a way I can clear the flag ? I tried reset and updating the firmware but it did not work .Is there a way I can clear it ?

Thanks,

Naveesh

over 6 years ago

0 Batt over 6 years ago

TI__Mastermind 42535 points

You can recover from OCC with a 200mA dsg if you are using standard settings. If not, reprogram the fw, it should work. By that I mean, flash the srec again.

0 Naveesh Boppana over 6 years ago in reply to Batt

Intellectual 430 points

Hi Batt,

I tried to update the fimware . It worked .

Thanks

0 Batt over 6 years ago in reply to Naveesh Boppana

TI__Mastermind 42535 points

Thank you for the update.

Power management

Power management forum

BQ40Z50-R1: BQ40Z50-r1