• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 259 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM5160-Q1: Boot resister of LM5160-Q1

takahiko yokota
Mastermind 7135 points
Part Number: LM5160-Q1

Hi

My customer evaluate LM5160-Q1 as Fly-Buck converter.
They are trying to reduce the radiated noise on thier board. 
They put the resister in series with boot capacitor.
Are there the recommending value of that resister?

Best regards,
Yokota

 

  • 0
    TI__Mastermind 33050 points
    hello Takahiko,

    You can try a 5 to 10 ohm resistor in series with the Boot capacitor.

    You can also try a RC snubber from Switch to Gnd. Try a 1 ohm and a 100p from Vsw to Gnd. Can start increasing the 100pF to 1nF gradually to obtain more noise attenuation. Watch the power dissipation in the 1 ohm as you increase capacitence. May have to use a larger size to disspate heat depending on the input voltage. The power dissipation in the 1 ohm is equal to C*V^2*Fsw. Where C = snubber cap, V = Input voltage and Fsw = switching frequency.

    Hope this helps?