TPS3420: push button solution which will keep status

Ann_Lien

Part Number: TPS3420

Hi expert,

Customer is asking for solution which is similar like TPS3420 but will need to keep low or high status for output and toggle status to high or low at next pulse generated by push button. Do we have solution could support this application? Thanks a lot!!

Best regards,

Ann Lien

over 5 years ago

0 Marshall_Beck over 5 years ago

TI__Mastermind 30550 points

Hello Ann,

1. If PB pressed, the output will toggle from low to high and latch into high state? (or high to low and latch into low state)
2. At next PB press, the output will toggle and latch?

Am I understanding all the requirements?

0 Ann_Lien over 5 years ago in reply to Marshall_Beck

TI__Genius 11770 points

Hi Marshall,

Thanks for reply! But we only have one push button and only a pulse when push button is pushed. There is no architecture to keep status at low or high. Or do you have better comments for only one push button condition which cannot keep Hi/Lo status? Thanks a lot!!

Best regards,
Ann Lien

0 Marshall_Beck over 5 years ago in reply to Ann_Lien

TI__Mastermind 30550 points

Hi Ann,

My previous post were questions to determine the operation/circuit performance you needed.
It sounds like my assumptions were correct, but could you please draw either by hand or digitally the waveform you are trying to produce when the push button is pressed?

0 Abhinav.Sharma over 5 years ago in reply to Marshall_Beck

TI__Genius 9375 points

Ann,

It seems your question was resolved. I am going to close this for now, if you need more help on this topic please let us know.

Thanks,
Abhinav.

Power management

Power management forum

TPS3420: push button solution which will keep status