BQ51003: Calibrated transmitter for FOD calibration

thierry bonnet

Part Number: BQ51003

Hello

We have implemented the BQ51003 in our product and need to calibrate it for FOD. On your documentation you recommended to use a calibrated transmitter from AVID. This device is no more available.

Can you recommend an other brand or a way to ordre such a device ?

Can we use a Qi sniffer to perform the calibration ?

Thank you very much.

over 5 years ago

0 Bill Johns over 5 years ago

TI__Guru 70516 points

Hello

A Qi sniffer would not work for this application.

What is your power level for the device?

0 thierry bonnet over 5 years ago in reply to Bill Johns

Prodigy 25 points

Hello Bill,

Our power consumption on the receiver is small 0.2 W with a small coil corresponding to the diameter of a watch.

0 Bill Johns over 5 years ago in reply to thierry bonnet

TI__Guru 70516 points

I need more info on you system and application. We can discuss this in private offline. I will contact you.

0 Bill Johns over 5 years ago in reply to Bill Johns

TI__Guru 70516 points

Hello

Working with you off line on this question, will close post.

Power management

Power management forum

BQ51003: Calibrated transmitter for FOD calibration