• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 2 answers
  • Subscribers 63 subscribers
  • Views 518 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

EV2400 IC - MSP430 burnt - How to replace it?

Ev2400 module IC MSP430 burn, I Replace MSP430 update firmware but not communicate with bq evaluation software

EMS_SAP
Intellectual 540 points
Other Parts Discussed in Thread: MSP430F5529, EV2400, MSP430USBDEVPACK

Hello,

We had burnt the micro-controller by shorting one of the pins with a high voltage line. We purchased a new MSP430F5529 chip and soldered it on the PCB. 

We followed the steps that  mentioned  www.ti.com/.../slaa452c.pdf - go to section 5 of that document and it shows how to install a new firmware in MSP430 with USB interface as it already has an inbuilt bootloader.Download (MSP430USBDEVPACK) and flash former FW , On EV2400 board USB connector D+ and D- pin 0Volt, can you please tell me what should I do? how to resolve this problem7103.EV2400FW_0013.txt