Dear Ti Team,
I'm looking at BQ24295 chip.
I need to know how can I limit the output current in Pin PAD to 200 mA max.
Thank you in advance for your help.
Best regards
Hafedh
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Dear Ti Team,
I'm looking at BQ24295 chip.
I need to know how can I limit the output current in Pin PAD to 200 mA max.
Thank you in advance for your help.
Best regards
Hafedh
Hi,
Referring to the d/s 8.3.1.3, there is no boost current limit setting when the boost current is sourced from PMID pin, hence it is important not to overload the
boost current under this condition.
Thanks,
Ning.
Hefedh,
For parasites, the lower, the better. Please refer to 9.2 Typical Application on the d/s or the EVM User's guide at http://www.ti.com/lit/ug/sluuao5b/sluuao5b.pdf for the component recommendations.
Thanks,
Ning.