BQ40Z80: bq40z80

Adam

Expert 1195 points

Part Number: BQ40Z80

Hello,

I'd like to ask what is the difference between Relative and Absolute SOC?

Basen on what parameters are the above assesed?

Regards,

Adam

0 Batt over 5 years ago

Hi adam,

RSOC=Remcap/FCC

ASOC = Remcap/Design cap.

0 Adam over 5 years ago in reply to Batt

Expert 1195 points

Hi,

thank you.

Two additional questions:

- FCC value is determined after learning cycle OR is based on ChemID and number of cells?

- RemCap is calculated with Impedance Track algorythm, right? So based on ChemID?

Adam

0 Batt over 5 years ago in reply to Adam

Hi adam,

FCC is determined by Qmax and load rate as seen from avg I last run on init if your learning cycle is not done.

Remcap is based on OCV seen and is dependent on chem ID and FCC.

Power management forum