Hi E2E,
Good day!
Is it ok to an MCU USB signal to the BQ25886 in parallel with a USB connector?
Looking forward to your response.
Thank you and best regards,
Franz
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi E2E,
Good day!
Is it ok to an MCU USB signal to the BQ25886 in parallel with a USB connector?
Looking forward to your response.
Thank you and best regards,
Franz
Franz,
Are you referring to the D+/D- data lines? If so, you will need to program a 1 second delay before the MCU can begin communication over D+/D-. This 1 second delay is needed to allow the D+/D- sensing to occur. After 1 second, the charger's D+/D- pins go into Hi-Z and data communication can occur on the D+/D- lines.
Thanks,
Ricardo