This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
While running transient simulation on TPS54218, keep facing error " Operating Point Not Found".
Need your help to check on our simulation file for whats going on?
Was playing with Analysis parameter but not able to solve still.
Thanks!
Regards,
Hoong Weislvm531.TSC
Hi Hoong Wei,
Is the model is not working before you change the parameters or after changing the parameters?
Best regards,
Tanvee
Hi Tanvee,
Yes by default it works.
But after we modified it to our design then it stop working.
Thanks!
Regards,
Hoong Wei
Hi Hoong Wei,
Could you share the file where you are trying to capture the data? The attached file doesn't have any measurement point and I don't understand the purpose of R2 resistor (10 Ohm) in parallel to feedback divider that will drop the output voltage.
Best regards,
Tanvee
Hi Hoong Wei,
Did your issue is resolved? Please let me know if you still require help to solve it.
Best regards,
Tanvee