This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS1H100-Q1: IN pin; DIAG_EN pin recommended resistor value

Part Number: TPS1H100-Q1

Hello,

Is there a recommended resistor value between 3.3V MCU and EN pin?

what is the threshold? 

In case the design is diagnostic always enabled, DIAG_EN pulled to 3.3V, is there a recommended value for pull-up resistor?

what is the threshold? 

Thank you and best regards,

Billy