TPS2544: About the timing spec between EN and CTL

user4487274

Prodigy 130 points

Part Number: TPS2544

Hello,

We are planning to controll EN and CTL by EC.

Are there any timing spec about the controll between EN and CTL?

Thank you.

Katsuhiro

over 4 years ago

0 Ziv Zhang over 4 years ago

TI__Mastermind 18031 points

Hi Katsuhiro-san,

EN on will power all the block.

You can first setting CTRL and then EN.

For TI's policy, I will first click resolved button.

If you have any other concern, contact me any time.

If you think resolved, please help click 'Issue is solved button'.

Thanks.

0 user4487274 over 4 years ago in reply to Ziv Zhang

Prodigy 130 points

Hi Ziv-san,

Thank you for your reply.

How is the minimum delay time specification from CTL setting to EN on?

Regards,

Katsuhiro

0 Ziv Zhang over 4 years ago in reply to user4487274

TI__Mastermind 18031 points

Hi Katsuhiro-san,

I also don't know this spec.

I think it doesn't influence the results with different power setting sequence.

For TI's policy, I will first click resolved button.

If you have any other concern, contact me any time.

If you think resolved, please help click 'Issue is solved button'.

Thanks.

Ziv

0 user4487274 over 4 years ago in reply to Ziv Zhang

Prodigy 130 points

Hi Ziv-san,

You mentioned as follows previously.

>You can first setting CTRL and then EN.

Does it mean that the above procedure is not required, just recommendation?

Thank you.

Katsuhiro

0 Ziv Zhang over 4 years ago in reply to user4487274

TI__Mastermind 18031 points

Hi Katsuhiro,

It's the recommendation.

CTRL is the input pin and must have a definite voltage level before powered on.

So it's suggested to set CTRL pin first then enable.

For TI's policy, I will first click resolved button.

If you have any other concern, contact me any time.

If you think resolved, please help click 'Issue is solved button'.

Thanks.

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Power management

Power management forum

TPS2544: About the timing spec between EN and CTL