BQ28Z610: Setting STATE and IT registers for learning cycle

Michael Balourdas

Part Number: BQ28Z610

Hi all,

I'm not entirely sure how to modify the State and IT config registers for a learning cycle. Do I even need to modify them?

Thanks,

Michael

0 Andy Liu (BMS) over 5 years ago

Hi Michael,

Andy

0 Michael Balourdas over 5 years ago in reply to Andy Liu (BMS)

Andy,

Thanks, I've looked through that before but wasn't sure if I was missing anything.

One more question: how do I know what to set Min Delta Voltage to? There's a reference to it in the TRM but I can't find any guidance on the value.

-Michael

0 Andy Liu (BMS) over 5 years ago in reply to Michael Balourdas

Hi Michael,

You can use its default settings since you will do a learning cycle. See Page 30 of bq28z60 TRM for some details.

Andy

Power management forum