My customer using TPS61099 and fund 3pcs( of 200pcs) FB over spec. cause Boost voltage is a little bit HIGH.
Pls double check if below FB is make sense? How about the range?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
If it's operating in burst mode, the ripple will larger than normal. And if you measure the Vout (same as FB pin), you will find the different from PWM mode. (Like figure 19 in datasheet)
And we don't guarantee an exact spec for its range.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs and
embedded processors, along with software, tools and the industry’s largest sales/support staff.