LM5019: P2P replace LM5017 for lower Iout requirement?

Jason Dai

Part Number: LM5019
Other Parts Discussed in Thread: LM5017,

Hello E2E,

May I have your support to take a look whether customer could directly replace lm5017 by using lm5019 on PMP7383 reference design?

Customer only require 3v3/0.1A at isolated channel output and keep 3v3/0.05A at non-isolated channel output.

Sincerely,

Jason

0 Frank De Stasi over 3 years ago

Hello

The two devices are very similar.

Please consult the data sheet for both devices and

also use the calculator tool on the product folder to

help with your design.

If you have any specific questions, please let us know.

Thanks

0 Frank De Stasi over 3 years ago in reply to Frank De Stasi

Hello

I hope that your question has been answered.

I will close this post.

Thanks

0 Jason Dai over 3 years ago in reply to Frank De Stasi

Frank,

I checked the both spec and think that it is no problem to p2p replacement.

I am not sure if i miss something to compare.

would you mind helping us double check again?

Sincerely,

Jason

0 Frank De Stasi over 3 years ago in reply to Jason Dai

Hello

I spoke with the application engineer for these products.

He confirms that the only difference is the current capability.

Thanks

Power management forum