Hi,
I am using BQ25155 battery charger IC in my design. Have a query about "wake from ship mode" which one of the below statement is accurate.
1) While trying to take BQ25155 out of shipping mode, is it good enough just to connect power to VIN pin (Reason: Just before figure 18 of data sheet states, "In the case where a valid VIN (VIN > VUVLO) is connected prior to WAKE2 timer expiring, the device will exit the ship mode immediately regardless of the MR or wake timer state.")
2) MR should be held low for a short time(longevity of time is not important) & connect power to VIN pin.(Reason: Figure 19 of data sheet shows MR "held low" as a condition to move out of ship-mode).
We want to exit ship mode while inserting USB charging cable if there is any shareable design please share with me.
Thanks in advance.
Regards,
Pothirajan.K