If customer wants to capture Bode plot for TPS55288 I2C version silicon, what is the recommend way to do? Any setup suggestion?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
You need to use the external feedback mode to test the bode plot. Here's the step based on the TPS55288EVM board:
1. Set the jumper JP2 and JP3 according to the attached user guide section 2.2.2.
2. Set the TPS55288 silicon works in the external mode via I2C control, please refer to datasheet '7.6.4 VOUT_FS Register(Address = 4h)', set bit7(FB) to 1.
3. Inject the signal across R3 to test bode plot. (below picture shows the R3 location, it is in series with the upper side dividing resistor.)
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs and
embedded processors, along with software, tools and the industry’s largest sales/support staff.