TPS53319: About ROVP

Tsukui Yusuke

Guru 21930 points

Part Number: TPS53319

Hi,

Customers will not use the OVP function.
The data sheet recommends connecting the ROVP pin to GND if not used.
Is it OK to install a 0ohm (max 50mohm) resistor between the GND and ROVP pins?

Please let me know if 0ohm installation is a problem.

Regards,
Yusuke

over 5 years ago

0 Gerold Dhanabalan - Online Design Tools over 5 years ago

TI__Genius 14455 points

Hi Yusuke-san,

Using a 0 ohm to connect to ground should be ok. It is necessary that it be connected to ground when not using it.

Regards,

Gerold

0 Gerold Dhanabalan - Online Design Tools over 5 years ago

TI__Genius 14455 points

Hi Yusuke-san,

Using a 0 ohm to connect ROVP to ground should be ok. It is necessary that it be connected to ground when not using it.

Regards,

Gerold

Power management

Power management forum

TPS53319: About ROVP