Hi Team,
My customers are using the internal default configuration. May I ask whether they could use I2C to configure this LP875701-Q1?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Team,
My customers are using the internal default configuration. May I ask whether they could use I2C to configure this LP875701-Q1?
Hi,
Yes, They can use I2C to change some of the device parameters once PMIC supply and NRST signals are available (and MCU is able to write I2C command).
For more details on which register settings can be changed, please refer to the datasheet Register Map section.
Regards,
Murthy
Hi Murthy,
Thanks for your reply. Customer now use the default configuration. May I ask in what situation does customer need to configure by I2C? such as specific delay?
Or it is total enough by using the default configuration?
Hi Amelie,
Usually customers use the default configuration, but it is possible to set for example different startup delay, configure GPIOs or fault detection differently.
Thanks.
Regards,
Tomi Koskela