BQ25611D: Drop-in Replacement for BQ25601D

Bryan Murray

Part Number: BQ25611D
Other Parts Discussed in Thread: BQ25601D

Assuming the VBUS and VAC pins are tied together and BATSNS is unconnected on a given board, is there any reason why the BQ25611D would not be directly replaceable (i.e. "drop-in") for the BQ25601D?

over 5 years ago

0 Jeff F over 5 years ago

TI__Guru**** 180096 points

Hi Bryan,

You are correct about VAC and VBUS. However, BATSNS cannot be left unconnected as it is the sense point for battery regulation, unlike BAT pin, which is sense point and current output, in 601D. Also, several of the I2C registers are different.

Regards,

Jeff

0 Bryan Murray over 5 years ago in reply to Jeff F

Prodigy 40 points

Hi Jeff,

Thanks for the reply. I do have a follow-up question, per the "Pin Functions" table of the 611D datasheet, "If BATSNS pin is open or short to ground, BATSNS_STAT bit is set to 1 and charger regulates the battery voltage through BAT pin." Are you saying the datasheet is incorrect, am I interpreting it incorrectly or is there a caveat to the situation?

Bryan

0 Ning T over 5 years ago in reply to Bryan Murray

TI__Guru 62501 points

Bryan,

Will get back to you during business hours in the next week.

Thanks,

Ning.

0 Jeff F over 5 years ago in reply to Ning T

TI__Guru**** 180096 points

Hi Bryan,

The datasheet is correct. I am backup support for the holiday and didn't realize this device has that feature.

Regards,

Jeff

Power management

Power management forum

BQ25611D: Drop-in Replacement for BQ25601D