BQ28Z610: Export srec after seal

Jayden Li

Part Number: BQ28Z610

Hi team,

Our customer sealed the device before learning cycle and exported the gg file. They wonder if the gg file could be imported into a new program and then export the srec file for mass production. Thanks.

Sincerely,

Jayden Li

over 4 years ago

0 Wyatt Keller over 4 years ago

TI__Guru** 105600 points

Hello Jayden,

We recommend exporting the .srec from the device that went through calibration and learning to maintain the floating point numbers.

The .gg file does not contain the chem ID so that would have to be programmed before the .srec is exported, but yes you can do those steps.

Sincerely,

Wyatt Keller

0 Jayden Li over 4 years ago in reply to Wyatt Keller

TI__Expert 3225 points

Dear Wyatt,

Thanks for your quickly response!

I want to confirm with you that the gg file exported from the sealed device can be programmed into a new device and then exported the .srec for mass production, right?

Thank you again for your help all the time!

Sincerely,

Jayden Li

0 Nick Brylski over 4 years ago in reply to Jayden Li

TI__Mastermind 19195 points

Hi Jayden,

Do no seal the gauge until you have completed evaluation, programmed your golden file and are ready to ship.

Best regards,

Power management

Power management forum

BQ28Z610: Export srec after seal