EV2400: Have no NC Drill File in board files

Statham Su

Genius 4990 points

Part Number: EV2400

Hello Sir:

We are planing make EV2400 by our self.

But we check the board files (sluc674) that has no NC drill file inside.

We cannot to make a PCB.

Can you provide it for us?

Thanks a lot.

over 4 years ago

0 Wyatt Keller over 4 years ago

TI__Guru** 105760 points

Hello Statham,

Let me check with someone else on the team if we can share the file.

Sincerely,

Wyatt Keller

0 Statham Su over 4 years ago in reply to Wyatt Keller

Genius 4990 points

Hi Keller:

Thanks a lot your support again.

Please let me know the status.

0 Jessica H. over 4 years ago in reply to Statham Su

TI__Genius 11535 points

Hi Statham,

We are waiting to verify that it is OK to share these files on e2e. I will give you an update once I find out.

0 Statham Su over 4 years ago in reply to Jessica H.

Genius 4990 points

Hi Jessica:

Please update the status for us.

Thanks a lot.

0 Jessica H. over 4 years ago in reply to Statham Su

TI__Genius 11535 points

Hello Statham,

Can the customer use the schematic from the user's guide and rebuild them in Altium? We don't have the Rev G build files readily available to share on e2e.

0 Statham Su over 4 years ago in reply to Jessica H.

Genius 4990 points

Hello Jessica:

Can you provide .sch of Altium for us?

We can try to rebuild the gerber file by our self.

Thanks.

0 Jessica H. over 4 years ago in reply to Statham Su

TI__Genius 11535 points

Hi Statham,

There is a schematic in the EV2400 User's Guide: www.ti.com/.../sluu446

Power management

Power management forum

EV2400: Have no NC Drill File in board files