TPS25750: How to receive I2Cs irq event on EVM kit

Alan Chang1

Other Parts Discussed in Thread: BQ25703A, TPS25750

Hi sir,

We got TPS25750 + BQ25703A EVM and want to check have irq event when usb cable plug in/out. However, the irq is always pulled LOW even usb cable does not plug in.

Already check the status is in 'APP' mode (Read Reg. 0x03 is' 'APP')

Have any suggestion to check it?

Thanks.

over 4 years ago

0 Hari Patel1 over 4 years ago

TI__Genius 12700 points

Hi Alan,

Unfortunately, at this moment you will not be able to set the IRQ events with the current Web GUI Tool. However, we will be releasing an update to the current version which will allow you to do so.

Thank you,

Hari

0 Alan Chang1 over 4 years ago in reply to Hari Patel1

Prodigy 55 points

Hi Hari,

May I know the schedule that when be able to set on Web GUI tool?

Besides, will gpio event also support to configure on Web GUI tool?

Thanks.

0 Chuck Branch over 4 years ago in reply to Alan Chang1

TI__Mastermind 32441 points

Alan,

The current target for the GUI release is the end of this month.

The major addition to the GUI is the ability to configure GPIO events.

Regards,

Chuck

Power management

Power management forum

TPS25750: How to receive I2Cs irq event on EVM kit