• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 440 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCC29002: spike on LS pin

CHEN YAN
Intellectual 1430 points
Part Number: UCC29002

Hi, expert

My customer is using UCC29002 but found a spick on the LS pin, the schematic and issued waveform are as following, could you please help analysis the reason behind? Thanks.

Best Regards

Chen

  • 0
    TI__Genius 9790 points

    Hi, Yan

    what is topology of this application?

    I've assigned your post to expert, pls expect a response by Thursday. 

    Yunsheng

  • 0 in reply to Yunsheng Qu
    TI__Genius 9140 points

    Hi, Yan,

    LS signal represents the load signal for the module with the highest load current.

    if there is spike on LS pin, I would suggest firstly to check whether each module is loop stable, then pay attention to the layout of the current sharing circuit.

    • Best to route the Ls signal away from any source of switching noise.
    • single point groiund is important.
    • Low impedance busbar is also important.
    • it is not allowed to add any filter or external circuit on the LS pin.