WEBENCH-POWER-DESIGNER: Unable to create/use custom part

Noah L

Part Number: WEBENCH-POWER-DESIGNER
Other Parts Discussed in Thread: LM3481

I am attempting to use a custom part in a design for a SEPIC converter using the LM3481.

After entering the custom part specs, WEBENCH seems to attempt to reload the design which then hangs infinitely. Examining the browser console reveals a few errors:

Any ideas on how to resolve this issue? I would like to use a part that is not already known by WEBENCH but have been unable to do so.

over 4 years ago

0 Shaheen Makandar over 4 years ago

TI__Expert 3110 points

Hi Noah,

Thanks for the post. Could you please let us know which component in the schematic you are trying to use as custom ?

Regards,

Shaheen S M

0 Shaheen Makandar over 4 years ago in reply to Shaheen Makandar

TI__Expert 3110 points

Hi Noah,

We have not heard from you for long time. We will be closing this post for now. If you have any further queries please reply here to open the post or create a new e2e thread if this post is locked.

Thanks & Regards,

Shaheen S M

Power management

Power management forum

WEBENCH-POWER-DESIGNER: Unable to create/use custom part