• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 265 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

UCC24636: DRV ON time

UCC24636: SR timing delay

kura
Genius 4790 points
Part Number: UCC24636

Our customer found folloing SR timing delay waveform. (delay time: about 550ns)

 

<Condition>

IN:DC240V-DC340V

OUT:13.5V/4A

 


 

Also they didn't found low Vin and light load condition.

 

CH1:Primary FET_VDS

CH2:Secondary FET_VGS

CH3:Secondary FET_VDS

CH4:Vout (AC mode)

 

Fsw:116kHz

Primary FET ON time:1.35us

Please let us know why these waveform is found.

They think these waveform have an impact on efficiency.

If you need any other information,please let us know it.

Regards,

  • 0
    TI__Expert 7080 points

    Hi Kura,

    The SR MOSFET turn on is determined when the SR MOSFET body diode starts conducting and the VPC pin voltage falls to near zero. from the waveform we can see the SR body diode already conducted , another turn on criteria is VPC pin voltage falls to near zero. there is a RC time constant on VPC pin which can delay the secondary voltage detection by VPC pin. R is VPC pin divider resistors and C is the VPC pin parasitic capacitance. if there is a ground plane under the divider resistors and VPC pin trace , it will worse the turn on delay.

    Solution is try to reduce parasitic capacitance(remove ground plane if have and place Rvpc2/Rvpc1 as close as controller to short VPC routing trace) and decrease Rvpc2 resistance then re-calculate Rvpc1.

    Thanks.