Other Parts Discussed in Thread: BQSTUDIO, EV2400
according to 5.5 CC Offset in TRM i can't pass this condition CCA == 1
there is any expected suggestion to overcome that issue?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello Gehad,
You can use bqStudio to calibrate an average a few PCBs then export the golden image to other gauges for production.
Sincerely,
Wyatt Keller
i use my custom PCB SO I USE MICROCONTROLLER TO EXCUTE THE CALIBRATION SEQUENCE
there is any technical info about that?
Hi Gehad,
Commands and sequence are described in TRM figure 5-3. If it's still not working, connect SDA, SCL and GND of the device to a EV2400 and do the calibration on bqStudio, thanks!
i don't have the required hw installation for that but i think it can be done by microcontroller software according to TRM Commands and sequence are described in TRM figure 5-3 as you said