TPS63806: Simulation Error

Akash Tripathi1

Part Number: TPS63806

Hi Team,

I am implementing the TPS63806 for a customer. The schematic is as follows-

I am getting the following warning-

i.e. WARNING(ORPSIM-15256): <X_U1.STEADY_STATE> not a subcircuit param

Please let me know at the earliest, if I am missing out on anything or if the problem is with respect to the software and how do I rectify it?

Thanks & Regards,

Akash Tripathi

0 Jasper Li over 3 years ago

Hi Akashi,

it is warning, did you get the result? or the simulation was terminated.

0 Akash Tripathi1 over 3 years ago in reply to Jasper Li

Hi Jasper,

The circuit is designed for a Vout of 3.3V but I am getting Vout and Iout very close to zero as you can see below-

Please let me know how to rectify this.

Thanks & Regards,

Akash Tripathi

0 Jasper Li over 3 years ago in reply to Akash Tripathi1

Hi Akash,

did you add the .lib file to the library? I also need time to try the simulation.

0 Jasper Li over 3 years ago in reply to Jasper Li

Akashi-san,

did you solve the issue. the simulation is good as below.

Power management forum